•Produces a brilliant polish quickly and efficiently
•Works faster than other similar products
•Does not etch or leave swirls easily
•Works on many difficult to polish marbles
•Goes further than other similar products
XXX Shine is a premium grade polishing powder for restoring a
beautiful natural polish on marble, travertine, limestone, and terrazzo.
Ideal for final polish of restoration projects or the periodic maintenance
of polished stone when traffic wear or etching occurs.
Contains: Oxalic acid dihydrate (CAS#6153-56-6), Potassium Hydrogen Oxalate
Causes serious eye damage. Harmful if swallowed. Harmful in contact with skin.
Prevention: Wash face and hands thoroughly after handling. Wear protective
gloves/protective clothing/eye protection/face protection.
Response: IF SWALLOWED: immediatley call a POISON CENTER or doctor/
physician. Rinse mouth. IF ON SKIN: Wash with plenty of soap and water. IF IN
EYES: Rinse cautiously with water for several minutes. Remove contact lenses,
if present and easy to do. Continue rinsing. Immediatley call a POISON CENTER
Disposal: Dispose in accordance with the local, regional, national and/or
international regulations. (See SDS sheet)
precautions before using this product.Use On:
Marble, travertine, limestone, terrazzo and other calcium based
stones capable of taking a polish.
Equipment: Slow speed (140 rpm-175rpm) floor machine, natural pad, commercial
wet vacuum, mop and bucket with ringer and floor squeegee.
Coverage: 250+ sq. ft. per pound
Always test in inconspicuous area prior to general use.
For professional use only!
Protect all adjacent surfaces with Tape & Drape masking film. Remove any existing
coatings (wax or floor finish) with Majestic Deep Cleaner Stripper Degreaser,
Majestic Intensive Cleaner, or Majestic Ultra Strip. Test in an inconspicuous area
prior to general use to confirm results. Keep a small window squeegee handy
for checking progress and results. Wet an area of approximately 9 sqft to 25 sqft
with clean water. Apply 2 tablespoons of XXX Shine in a small line of about 12”
in length. Place a natural hair pad on the line of powder as if the powder were a
spoke of a wheel and so the powder will work in a sweeping motion.
Using a slow speed (140 rpm – 175 rpm) floor machine, work the slurry in
the selected area for several minutes and check results with squeegee. When
satisfactory results are achieved, wet vac the area, flood rinse with clean water
and wet vac again. Move to the next area to be polished. Complete large areas
in a checkboard fashion, overlapping areas to blend.
Note: The amount of water, number of passes, and weight of machine are some
of the variables that can be adjusted to get the best performance. Can be used
to touch up traffic lanes or small areas. Use slow consistent passes with the floor
machine. Product contains acid so do not leave unattended or allow to dry on